Macrom 44.07 - Settings and Selectors

MACROM INGLESE 44.05/07 14 OTTOBRE 1992 13
SETTINGS AND SELECTORS
13
+
-
+
-
-+
A B
E
4CH 3CH 2CH
LOW PASS
HIGH PASS
ONOFF
ONOFF
OUTPUT
INPUT
2CH4CH
+
-
+
-
-+
C D
F
C
D
A / E
B / F
GAIN
CONTROL
0.5V
0.1V
2 V
GAIN
CONTROL
0.5V
0.1V
2 V
LEFT
BY-PASS
OUTPUT MODE SELECTOR WITH 2 INPUT CHANNELS AND A BY-PASS OUTPUT
a) "2CH
INPUT" "4CH OUTPUT" MODE: As your head unit is equipped with only two pre-amplified
outputs select the position “2CH” and connect the outputs to the amplifier inputs marked with the
letters A / E (left) and B / F (right). Then select the position "4CH" in order to have 4 output
channels, A, B, C and D, respectively, to drive 4 speakers. You can then activate (ON) the
different sections of the built-in electronic crossover to obtain the High-Pass outputs A and B and/
or the Low-Pass outputs C and D.
NOTE: In case a preamplified output is needed to control another amplifier, the RCA-connectors
C and D marked BY-PASS and carrying a unitary gain output signal can be used.
The By-Pass output is active only with the "2CH
INPUT" configuration.
IMPORTANT NOTE: Both input sensitivity adjustments are activated and operate independently
on the respective outputs.
+
-
+
-
-+
A B
E
4CH 3CH 2CH
LOW PASS
HIGH PASS
ONOFF
ONOFF
OUTPUT
INPUT
2CH4CH
+
-
+
-
-+
C D
F
C
D
A / E
B / F
GAIN
CONTROL
0.5V
0.1V
2 V
GAIN
CONTROL
0.5V
0.1V
2 V
LEFT RIGHT
b) "2CH INPUT" "3CH OUTPUT" MODE: This configuration uses a single 44.05/44.07 amplifier as a
multi-amplifying system. There are 3 output channels, 2 stereo channels A and B, and a third
channel F with a single bridged mono signal.
In case you want to use the built-in electronic crossover, the outputs A and B can be connected
to medium-high speaker systems by placing the High-Pass selector in the ON position , whereas
by placing the Low-Pass selector in the position ON a woofer system or a powerful subwoofer
can be connected to the mono output F.
IMPORTANT NOTE: Both input sensitivity adjustments are activated and operate independently
on the respective outputs.
+
-+-
-
+
A B
E
4CH 3CH 2CH
LOW PASS
HIGH PASS
ONOFF
ONOFF
OUTPUT
INPUT
2CH4CH
+
-+-
-
+
C D
F
C
D
A / E
B / F
GAIN
CONTROL
0.5V
0.1V
2 V
GAIN
CONTROL
0.5V
0.1V
2 V
LEFT RIGHT
c) "2CH INPUT" "2CH OUTPUT MODE: This configuration uses the amplifier as a traditional and
powerful 2-channel stereo system with the output channels E and F.
On activating the built-in electronic crossover, Low-Pass ON with this configuration, only the low
frequencies are output for driving two powerful subwoofers.
IMPORTANT NOTE: With this configuration only one of the two input sensitivity controls (the
right one) is activated for the adjustment of the signal at the E (left) outputs.
BY-PASS
BY-PASS