Madimack ECO - Sensor Failure Troubleshooting

46
Power surge
2). Replace Inverter board
P1
Water inlet temp sensor failure
The water inlet temperature
sensor is either damaged or
running a short circuit
Check the Temperature sensor at the water inlet, might
need to be changed
P2
Water outlet temp sensor failure
The water outlet temperature
sensor is either damaged or
running a short circuit
Check the Temperature sensor at the water outlet,
might need to be changed
P3
Gas exhaust temp sensor failure
The sensor is running a short
circuit, damaged, or not fixed
properly
Check the gas exhaust Temperature sensor, might need
a replacement
P4
Evaporator coil pipe temp sensor
failure
The sensor is running a short
circuit, damaged, or not fixed
properly
Check the evaporative coil pipe Temperature sensor,
might need a replacement
P5
Gas return temp sensor failure
The sensor is running a short
circuit, damaged, or not fixed
properly
Check the Gas return Temperature sensor, might need a
replacement
P6
Cooling coil pipe temp sensor
failure
The sensor is running a short
circuit, damaged, or not fixed
properly
Check the cooling coil pipe Temperature sensor, might
need a replacement
P7
Ambient temp sensor failure
The sensor is running a short
circuit, damaged, or not fixed
properly
Check the Ambient Temperature sensor, might need a
replacement
P8
Cooling plate temp sensor failure
The sensor is running a short
circuit, damaged, or not fixed
properly
Replace inverter board
P9
Current sensor failure
The sensor is running a short
circuit, damaged
1). Replace inverter board for single phase model
2). Replace power filter plate for 3 phases model