What to do if my Madimack Elite Max Heat Pump shows F8 Cooling plate overheat protection?
If your Madimack Heat Pump displays error code F8, indicating cooling plate overheat protection: 1. Power off and restart the system. 2. Check the fan motor. 3. Check the cooling plate.
Why is the fan running but with insufficient heating in my Madimack Elite Max?
If the fan is running on your Madimack Heat Pump but the heating is insufficient, check the following: * Make sure the air outlet is not blocked and remove any obstructions. * Remember there's a 3-minute start delay, so wait patiently. * Ensure the set temperature is appropriately high for heating.
What to do if the power switch is off on my Madimack Elite Max?
If the power switch of your Madimack Heat Pump is off, switch it on.
What to do if my Madimack Heat Pump shows E1 High pressure protection?
If the Madimack Heat Pump displays error code E1, indicating high pressure protection, the issue might stem from the high water flow pressure switch. Check the water flow from the filtration pump. Also, inspect the sensor's electrical connection. If necessary, replace the faulty sensor, pressure switch, or circuit.
What to do if my Madimack Heat Pump shows P8 Cooling plate temp sensor failure?
If your Madimack Heat Pump displays error code P8, indicating cooling plate temp sensor failure, it means that the sensor is running a short circuit, damaged, or not fixed properly. Replace the inverter board.
What to do if my Madimack Heat Pump shows P9 Current sensor failure?
If your Madimack Heat Pump displays error code P9, indicating current sensor failure, it means that the sensor is running a short circuit or damaged. For a single-phase model, replace the inverter board. For a 3-phases model, replace the power filter plate.
What to do if my Madimack Heat Pump shows F1 Compressor drive module failure?
If your Madimack Heat Pump displays error code F1, indicating compressor drive module failure, it is due to lack of phase. Check the voltage and the frequency conversion.
What to do if my Madimack Elite Max Heat Pump shows F3 Compressor start failure?
If your Madimack Heat Pump displays error code F3, indicating compressor start failure, it is due to compressor circuit. Check the compressor wiring if its correct or if there is any short circuit.
What to do if my Madimack Elite Max Heat Pump shows P2 Water outlet temp sensor failure?
If your Madimack Heat Pump displays error code P2, indicating water outlet temp sensor failure, it means that the water outlet temperature sensor is either damaged or running a short circuit. Check the temperature sensor at the water outlet; it might need to be changed.
What to do if my Madimack Elite Max Heat Pump shows E4 3 phases sequence protection?
If your Madimack Heat Pump displays error code E4, indicating 3 phases sequence protection, it is due to the electrical power connection. Check the power connection to the pump.
To Next Page
General
