- 8 -
3. OPERATIONS
3.1 STARTING / STOPPING ENGINE
[ STARTING OF ENGINE ]
1. Insert the key into the starter switch, turn and hold the
key in the “ON” position, and wait until the “WARM-UP
MONITOR” indicator lamp goes out.
NOTES
When the starter switch key is turned to the “ON” position,
the “WARM-UP MONITOR” indicator lamp lights up to
indicate that the engine is being warmed up.
When the engine has been warmed up, the “WARM-UP
MONITOR” indicator lamp goes out.
2. When the “WARM-UP MONITOR” lamp goes out, turn the
key to the “START” position.
3. When the engine has started, release your hand from the
key.
The key automatically returns to the “ON” position.
[ STOPPING ENGINE ]
1. Take your foot off the accelerator pedal (6), let the engine
idle for about 5 minutes with no load applied.
2. Turn the starter switch key to the “OFF” position.
The engine stops.
3. Remove the starter switch key.
To Next Page
Loading...
