OPERATION
STARTING CHECK
Operating manual T225 / 230 95
In case of a malfunction at the sensor, check the oil
level with the oil dip stick. In case the oil level is
correct, but the error at the sensor “oL FL” is still
displayed, contact customer service to rectify the fault.
Ending the oil level check
X Press both arrow keys 1 and 2 until “N - N” is visible in the
display.
Fuel supply
Check the level on the fuel gauge before you operate the MT.
It is indicated by the fuel gauge of the combination display
instrument. If the level is low, refill fuel see “Refuelling” on
page 106.
Oil level sensor
error
Cause
oL 0X Settling time too short Setting time is too short
oL EL Engine speed Low Motor speed is too low
oL EH Engine speed High Motor speed is too high
oL SN Select Neutral Not in neutral
oL TL Temperature Low Oil temperature is too low
oL TH Temperature High Oil temperature is too
high
oL SH Outputspeed High Drive shaft is turning
(MT is moving)
oL FL Sensor Failure Malfunction at the sensor
To Next Page
Loading...
