Magellan eXplorist 100 - Multi-Leg Routes

Multi-Leg Routes
Multi-leg routes can be used to navigate to a final destination using multiple legs. An
example would be leaving the dock, motoring over to buoy 1, then the bait boat, and finally
to a fishing hot spot. This route would go from Dock to Buoy 1,Buoy 1 to Bait, Bait to Fish.
Features of a multi-leg route:
• Multi-leg routes can be saved in memory. (A maximum of 20 routes can be saved. Each
saved route can have up to 29 legs in the route.)
• Multi-leg routes remain active even after the eXplorist has been turned off.
• Multi-leg routes can be edited, reversed, deleted, or viewed on the plotter.
• When a multi-leg route is active, you can switch which leg will be used as the next
destination point. In the above example, you could skip going to Buoy 1 by selecting
the Bait leg when the route is active.
Routes
35