OPERATION AND MAINTENANCE MANUAL
THREE PHASE MCRII SERIES BATTERY CHARGER
Rev: 1.6 03/08/2010 Doc: MAN-3P_MCRII_REV1.6.Doc Page 22 of 29
Magellan Powertronics
68 Cocos Drive, Bibra Lake, WA 6136 Tel: 08 94346621 Fax: 08 94346623
The Charger Control O/P set point (displayed on the LCD Display) will remain fixed, and the
charger output voltage is adjusted up or down to match the setpoint by the front panel arrow
keys.
Load Voltage Calibration Calibrates the load voltage meter reading.
Battery 1 Voltage Calibration Calibrates the Battery 1 volt meter reading
Battery 2 Voltage Calibration Calibrates the Battery 2 volt meter reading
Charger Voltage Calibration Calibrates the Charger voltage meter reading.
Charger Current Calibration Calibrates the charger output current meter
Charger Current Offset Calibration Calibrates the charger output current offset
Battery 1 Current Offset Calibration Sets the zero point on the Battery 1 current meter
Battery 2 Current Offset Calibration Sets the zero point on the Battery 2 current meter
Battery 1 Current Calibration Calibrates the Battery 1 current meter
Battery 2 Current Calibration Calibrates the Battery 2 current meter
Bridge Voltage Calibration Calibrates the SCR bridge output voltage reading
Charger Output Control Calibration Calibrates the charger output control
Temperature Offset Calibration Calibrates the Battery temperature readings.
Sub Menu 9 Communications Set up
This sub menu is used to select and set the parameters for communication with the charger.
Details are given in the MCRII Remote Communications Manual supplied with the MCRII
Remote Communications Package.
Sub Menu 10 Diagnostic Set up
This sub menu is used to set the charger into a self diagnostic mode.
Diagnostic Level 1 Setting to On gives enables the level 1 diagnostic
Diagnostic Level 2 Setting to On gives enables the level 2 diagnostic
To Next Page
Loading...