OPERATION AND MAINTENANCE MANUAL
THREE PHASE MCRII SERIES BATTERY CHARGER
Rev: 1.6 03/08/2010 Doc: MAN-3P_MCRII_REV1.6.Doc Page 8 of 29
Magellan Powertronics
68 Cocos Drive, Bibra Lake, WA 6136 Tel: 08 94346621 Fax: 08 94346623
CONTROLS
The following adjustments can be done by the software:
Float Voltage Adjustment
Boost Voltage Adjustment
Boost Timer Adjustment
Charger Current Limit Adjustment
Battery 1 Current Limit Adjustment
Battery 2 Current Limit Adjustment (for dual battery systems)
Load Sense Boost Inhibit
DC Low Alarm Adjustment
DC High Alarm Adjustment
High Volts Inhibit
High Volts Disconnect Adjustment
Low Volts Disconnect Adjustment
Battery Fail Voltage Adjustment
The following adjustments can be done using on-board potentiometers in
chargers provided with optional Hardware Output Over and Under Voltage
Trip:
Over Voltage Trip Level
Under Voltage Trip Level
Over Voltage Trip Delay
Under Voltage Trip Delay
Please refer to the CHARGER TEST SHEET in Appendix 1 for details specific to this
charger.
To Next Page
Loading...