-20-
SERVICE
EXPLANATION OF FAULT CODES
Your appliance is equipped with an electronic control featur-
ing built-in, self-diagnostic software. This software continu-
ously monitors the control to insure safe and proper opera-
tion. If the software should detect a questionable situation, a
FAULT CODE (F plus a number) will appear in the display
and continuous beeps will sound.
A fault code indicates that there may be functional error. As a
safety precaution, the control will automatically cancel the
program. Follow the procedures described to check the ap-
pliance.
DURING NORMAL OVEN COOKING
If a fault code appears in the display and continuous beeps
sound, press the STOP/CLEAR pad. Then, reprogram the
cooking operation.
If the fault code reappears in the display, call a servicer. Do
notuse theoven untilthe control has been serviced. Thesur-
face unit can be used.
DURING A SELF-CLEAN CYCLE
If the oven is heavily soiled, excessive smoke and flaring
may result in a fault code. If this occurs, press the STOP/
CLEAR pad and allow the oven to cool for an hour. Then,
reprogram the oven for the clean cycle.
If the fault code reappears in the display, call a servicer. Do
notuse theoven untilthe control has been serviced. Thesur-
face unit can be used.
To Next Page
Loading...
