How to Use (Magic Codes) COOK CODE Control
¢
The COOK CODE Control oven can only be programmed to whole minutes only. If your recipe
provides a shortcut method for 99 minutes when using the COOK calls for power level changes or
entering time and the power level CODE control and the highest power different amounts of time needed
on your microwave oven. Cook level is 10which is represented by between addition of ingredients,
Codes are only used for recipes "07 When setting a 2 digit Cook you may set one Code for the first
which need little or no attention, Code control entry, the first is part of the recipe, then after
and which require no change of time, the second is power level. For completion, set another Code for
power level during cooking, example, 50 means 5 minutes at that period of time and power level.
Recipes which requireadditional power level 10. Remember that Cook Codes are for
ingredients, attention or change of On the following page aye shown microwaving by time only. If you
power level during microwaving many frequently prepared foods are microwaving by temperature,
should be cooked in the usual and their codes. It's easy, though, you must use the Temp Cook or
manner. Also, recipes with cooking to make Codes for many other Roast Code function.
time of less than one minute or recipes. Just select one or two When the oven completes Cook
more than 99 minutes cannot use digits representing the length of Code program, it automatically
Codes. cooking time desired, and a final shuts off. Itwill then display
To understand the Cook Code digit forthe power level required. "End" and beep once a minute
control, it is important to know The Codes given on the chart are until you either open the door or
what the numbers mean and what for the minimum time needed to touch the OFF/RESET pad.
the sequence is. The first and avoid overcooking which can dry
second numbers, if setting a 3 digit out food and make it tasteless and
Code, indicate the amount of time tough. If you feel that more
you desire: the last control entry cooking is needed, add additional
number is always the power level, time by changing the first digit of
For example, 125 means 12minutes the Code. Youcannot add seconds
at power level 5. NOTE: Your to the cycle time--Codes are for
ForExample: How to Set
COOK CODE Control
Programming your oven for Cook
COOK CODE Code Control operation is easy.
2 Digit Follow these simple steps.
I101 -°
_ Step 2: Enter the proper Code. For
N
example, a recipe calling for 12
Time in PowerLevel minutes cooking time at power
Minutes High (10) level 10would be 120. 120appears
on the display panel.
COOK CODE Step 1: Touch COOK CODE.
3 Digit "Enter Code" flashes.
Step 3. Touch START. Display will
Time in PowerLevel show time counting down and
Minutes Med (5) "Cook Time:'
10
To Next Page
Loading...
