' Cooking byTemperature
t
Internal temperature is the best How to TempCook a Rolled Questions and Answers
test of doneness for many foods. Beef Rib Roast to Medium Q. After I followed the steps
"Temp Cook" takes the guesswork Step 1: Insert temperature probe and touched the START pad,
out of cooking because the oven and attach probe securely in oven "EE EE" flashed in the display O
automatically switches to "Hold" O
setting after reaching the preset food wall. Close the door. and a signal sounded. What's
wrong?
temperature and maintains that Step 2: Touch TEMP COOK. I=_.
temperature forup toone houror until "Enter Temp Cook" flashes. A. "EEEE" flashes if you set _l
the temperature either below 90°E
you touch the OFF/RESET pad. Step 3: Touch 1,2, 5 for 125°E or above 199°E The oven tells you,
"Temp Cook" flashes and "125" between the flashing of "EE EEl' _,m
The Temperature Probe shows on display, what incorrect entry was made. To ¢_
HANDLE CABLE Step.4: Touch Power pad. "P-" re-enter, touch OFF/RESET pad
and begin again.
El D appears on display. Touch 5 for k_
medium power. "Temp Cook;' Q. Are there any foods I can't _°
SENSOR CLIPI "125" and "P-5" show on display. Temp Cook?
The temperature probe is a food Step 5: Touch START. If internal A. Yes. Delicate butter icings, ice
thermometer that gauges the temperature of the roast is less than cream, frozen whipped toppings,
internal temperature of your food; 90°E, display will show -90 or if etc. soften rapidly at warm
it must be used when using "Temp temperature is 9ff'F. or above, display temperatures. Batters, doughs and
Cook" or "Roast Code_' To utilize shows temperature counting up. frozen foods are also difficult to
your probe properly, follow directions cook precisely v;,iththe probe. It's
for use and insertion in this book Step 6: After approximately half of best to Time Cook these foods.
in the section entitled "Automatic cooking time, open door and turn
Roasting? roast over. Close door and touch Q. Why did "PROB" flash on
start. (Remember to re-insert probe.) the display after I touched the
START pad?
Step 7: When 125°E is reached, A. "PROB" will flash if you
the oven will sound and display don't seat the cable end of the probe
"Hold? The oven will then hold
securely into the receptacle in the
the temperature.
oven wall or if you touch the TEMP
Step 8: Touch the OFF/RESET COOK pad and forget to use the
pad to stop the cycle, probe.
Step 9: Remove probe and food Q. Can I leave my probe in the t_
from the oven. oven if it's not inserted in food?
A. No, if it touches the oven wall,
Cooking Tips you may damage the oven. t_.
• Use a lower power level; it will Q. Can I Temp Cook different
heat more evenly even though portions of food at different
UM
requiring more time. temperatures?
• Be sure frozen food has been A. Yes. The temperature probe ¢_
completely defrosted before inserting gives you the freedom to cook
probe. Probe may break off if used different portions of food at
in frozen foods, different temperatures to suit
individual eating styles. Simply [_
• Use the clip to keep the probe in place probe in food and change
place while heating, temperature setting as needed. I_
• Cover foods loosely for moisture ._.
control and quick, even heating. _'-_
9
To Next Page
Loading...
