To replace hood, disconnect power To replace your oven lamp, first Clean off the grease and dust on
at main fuse or circuit breaker disconnect power at main fuse hood surfaces often. Use a warm
panel or pull plug. Remove 1 or circuit breaker or pull plug. detergent solution. About 1
screw from each side of lower panel Remove the top grill by taking off tablespoon of ammonia may be
and 3 screws from front edge. Lower 3 screws which hold it in place, added to the water. Take care not
panel until it rests on range below, to touch the filters and enameled
Be sure bulbs to be replaced are surfaces with this. Ammonia will
cool before removing. Remove bulbs tend to darken metal.
and replace with40 watt incandescent /_"L__F_--i; _ ?--7-'% _t_ "_ C[}
bulbs available from your supplier, t
Raise lower panel and replace i _ 1--_ O
screws. Connect electrical power
to microwave oven.
Next, remove the single screw
= - located above door near center of
___===__)( oven that secures lamp housing, i
Replace burned-out bulb with a
30-watt lamp available from your
REMOVE 7 SCREWS supplier.
Note:
Also remove the two screws
mounting the upper glass retainer
trim for easier lamp replacement.
O
19
To Next Page
Loading...
