Magic 105 - Water Drain

23
G
B
FIG. 7 - TRANSMISSION LEVER OFFSET UP TO 45 mm FROM THE GATE HINGES
A - DO NOT USE
B - Weld to the gate with the pivot, as shown in Fig. 7
FIG. 8 - TRANSMISSION LEVER GATE LOAD-BEARING SUPPORT
A - Use only when the gate weighs excessively on the motor.
B - Weld with the pivot inserted half-way into the transmission lever slot, as shown in Fig. 8
7 8
WATER DRAIN
WELD
POWER CABLE
WELD