Place the bowl on the motor unit with
the handle to the left hand side.
Wash all the parts thoroughly (except the motor unit) before using for the first time.
Place the chosen attachment in the bowl
(see details on following page).
Turn the lid anti-clockwise until locks
into place. The feed tube will now be
in the centre, in line with the handle.
Place the lid on top of the main bowl,
placing the feed tube to the left of the
handle.
Turn the bowl anti-clockwise making
sure it firmly locks into position. The
handle will now be at the centre of the
motor unit.
FITTING THE ACCESSORIESFITTING THE BOWL
WARNING
Double failsafe : the machine will
only work if both the bowl and the
lid are correctly locked into position
1 2
3
5
4
TO SLICE: place the disc with its slicing
blade facing upwards.
Lower the support, fitted with a disc, onto
the motor shaft in the centre of the bowl.
Put the lid on and lock into position.
TO GRATE: Place the disc with its grating
blades facing upwards.
BLENDER
m
IX: for use with the main
blade. For small quantities place it in the
bowl otherwise position it in the lid.
DISCS: place the selected disc on
the support, turning it gently in an
anti-clockwise direction.
Please be careful when handling the blades and disc as they are
extremely sharp.
!
STAINLESS STEEL MAIN BLADE: place the
blade directly in the main bowl, over the
motor shaft.
Put the lid on, and lock into position.
6 7
To Next Page
Loading...
Need help?
General
