16
AUTO PROGRAM (SETTING UP CHANNELS)
Y
our LCD TV can automatically set itself for local
area (or cable TV) channels. This makes it easy
for you to select only the TV stations in your area by
pressing the CH (+) or CH (-) button.
Press the MENU button on the remote
control to show the
onscreen menu.
Press the (CH-) button to
highlight the INSTALL menu.
Press the (VOL+) button
to enter the INSTALL menu.
Press the (CH-) button to
highlight the AUTO PROGRAM control.
Press the (VOL+) button to start the AUTO
PROGRAM scanning of channels.
Press the MENU button repeatedly to clear
the menu from the screen, after AUTO STORE
has finished.
1
2
3
4
5
6
After you’ve run Auto Program, check out
the results. Press the CH+ or the
CH- button and see which channels you can
select.
HELPFUL HINT
Remember, an antenna or cable TV signal
must first be connected to your LCD TV
(see pages 8-9 of this owner’s manual).
To Next Page
Loading...
Need help?
Picture/Display
Power
