71
Problem solving for programmed
recordings
PROBLEM SOLUTION
DVD recorder does not
respond
bWhile a programmed recording is being made, you cannot operate your DVD recorder
manually. If you want to cancel the programmed recording, press STANDBY m .
'Switch off, timer recording'
flashes on the TV screen.
bThe DVD recorder was switched on before the start of a programmed recording.
Turn off the DVD recorder by pressing STANDBY m . A programmed recording (timer) will
only function if the DVD recorder is switched off (button STANDBY m ).
Error message: 'Insert
recordable disc'
bEither no disc was inserted or a disc was inserted that cannot be used for recordings. Insert a
disc that can be recorded upon. Turn off the DVD recorder by pressing STANDBY m .
The message 'Disc locked'
flashes briefly on the
screen.
bA protected disc was inserted. Undo the erase protection or insert a different disc.
Error message: 'Memory
full'
bIf this error message appears after pressing TIMER , then all TIMER blocks are already
programmed. No more recordings can be programmed. Press the C button. If you want to
clear or check a programmed recording, select it with A or B .
The 'Data error' message
appears on the screen.
bThe data for the recording could not be transferred. Please check date, start time, and end
time of the programmed recording.
The message 'Collision'
appears on the screen.
bThe timer recorder overlaps with another timer recording.
bIf you ignore this warning, the programmed recording with the early start time will start first.
The second recording will then lack the beginning.
bChange the information from one of the two recordings.
bDelete one of the two recordings.
ENGLISH
Programming a recording (TIMER)
To Next Page
Loading...
Need help?
General
