Magner 75 - Sensor Error Codes

75 Series Currency Counter
21
Sensor Error Codes
Error Code Corrective Action
a Door Bill Guide Assembly is not closed / Close
(ALL MODELS) the Guide Plate Assembly to start.
bHJHopper Sensor is blocked / Remove the
(ALL MODELS) note(s) from the hopper to restart.
cSJStacker Sensor is blocked / Remover the
(ALL MODELS) note(s) from the stacker to restart
dJACount Sensor / Inline sensor(when in "S"
(ALL MODELS) mode of 75S/75SU/75SMU) is detecting a
note(s) in the machine.
e FEEd
(ALL MODELS) Feed Motor is not working.
f CSE Count Sensor(both left and right side)
(ALL MODELS) error/Clean the sensors to restart.
CSE1 Count Sensor(L) error / Clean the left
(ALL MODELS) side sensor to restart.
CSE2 Count Sensor(R) error / Clean the right
(ALL MODELS) side sensor to restart.
g CFE Magnetic Sensor(both left and right side)
(75MD/75SM/75SMU) error/Press CLR key to restart.
CFE1 Magnetic Sensor(L) error / Press CLR key
(75MD/75SM/75SMU) to restart.
CFE2 Magnetic Sensor(R) error / Press CLR key
(75MD/75SM/75SMU) to restart.
h UEE UV Sensor error / Press CLR key to
(75UD/75SU/75SMU) restart.
i ddE Inline Sensor (both left and right side)
(75S/75SM/75SU/75SMU) error/Clean the both sensors to restart.
ddE1 Inline Sensor(L) error / Clean the left side
(75S/75SM/75SU/75SMU) sensor to restart.
ddE2 Inline Sensor(R) error / Clean the right
(75S/75SM/75SU/75SMU) side sensor to restart.