8 PROGRAMS
Connect LP-HP coupling (or one of the couplings).
Open the flow to the coupling(s) by rotating appropriate wheels in the front panel of the
station clockwise. LP-HP indicators (or one of the indicators, depending on the
connection) indicate the pressure in both sections of the vehicle A/C system.
Press ENTER in standby mode.
Enter registration no.■
In Others menu □
Use UP and DOWN buttons to select the desired menu. Confirm by pressing ENTER.
Registration no.
If you do not wish to enter the registration number, select ENTER.
Enter the registration number using UP – DOWN buttons. See 8.3 Editing
Press and hold ENTER for 3 seconds to confirm the entry.
8.1 Recognizing overhauls performed in the past
If the station recognizes a registration number as already existing in the database, the
following message is displayed:
Try again ■
Previous service data □
Select TRY AGAIN and confirm by pressing ENTER to start servicing according to
previous maintenance parameters
select PREVIOUS SERVICE DATA and confirm by pressing ENTER to display the last
vehicle filling parameters.
UP and DOWN buttons allow viewing the following parameters:
Quantity of refrigerant filled
Vacuum generation time
Leak test duration
Pressure increase during the leak test
Feed oil? Yes/No
Feed contrast? Yes/No
Quantity of refrigerant recovered from the system
Select ENTER to confirm overhaul completion. See chapter 10 SINGLE PHASES
Select STOP/BACK to change the servicing parameters.
If no previous overhaul of the vehicle with specific registration number is found, or if the
option of selecting the station service parameters again is chosen, the following message
is displayed:
Due to frequent improvements to the station
software, minor discrepancies between the data in the
manual and the actual reality may occur.
Some longer
messages are displayed
by scrolling the text on
the display. In this
manual these are
presented as continuous
strings.
To Next Page
Loading...