How to troubleshoot a Magnetrol J30 Switch when the pump won't start?
If the pump won't start or stop, or the signal lamps fail to light, check the fuses, reset button(s), power switch, controlled equipment, and wiring.
What to do if the Magnetrol J30 mechanism fails to actuate?
If the Magnetrol Switch mechanism fails to actuate, there could be several reasons: 1. Binding: Loosen the magnet clamp screw and shift the magnet position, then retighten the screw. 2. Improper Installation: Ensure the control is installed within 3° of vertical. 3. Damaged Microswitch: Check the microswitch continuity with an ohmmeter and replace it immediately if damaged.
What to do if the Magnetrol Switch float is not buoyant in the liquid?
If the float in your Magnetrol Switch is not buoyant in the liquid, it may be filled with liquid or collapsed. Replace the float immediately.
Identifies potentially dangerous situations or serious hazards.
Instructions for unpacking the instrument and checking contents.
Instructions for mounting the instrument, emphasizing vertical alignment.
Details on grounding, high-temperature wiring, and terminal connections.
Steps for rotating the switch housing and connecting wiring.
Guidance on piping arrangement, support, and insulation for the control.
Details adjusting differential for low level controls.
Provides step-by-step instructions for low level control differential adjustment.
Explains how to adjust differential for high level controls.
Details steps for replacing the float and stem assembly.
Guides on checking the switch mechanism for proper operation.
Steps to check the float, stem, and attraction sleeve for issues.
Explains the model number coding system.
General| Category | Switch |
|---|---|
| Type | Level Switch |
| Material | Stainless Steel |
| Connection | Threaded or Flanged |
| Switch Action | Snap Action |
| Output Signal | SPDT or DPDT |
| Technology | Magnetic |
To Next Page