MAHA PTI Tool - Manufacturers Diagnosis: Test Procedure (EUROSYSTEM 7.50)

10
BAZ72501-en
3.5
Manufacturer’s Diagnosis: Test Procedure (EUROSYSTEM 7.50)
1 You can start the vehicle diagnosis under Test procedure > PTI Tool.
2 After selecting the manufacturer, series and model you can:
a) start the AutoScan using <F5>.
b) display a picture of the diagnostic interface (if available) using <F6>.
3 After a successful AutoScan you can:
a) save the measurement using <F5>.
b) start a new measurement using <F8>. This will discard previous
measurements.
c) start a printout of the test results using <F12>.