BAZ72501-en
5 If more than one device has been configured, choose the active PTI Tool, then
< Continue>.
6 After a successful communication setup you can perform the following
diagnostics:
End communication
RPM, Temperature
Diagram O2 sensor voltage: oscilloscope for RPM and O2 sensor
voltage/current
Control loop test: lambda probe diagnosis
Read error memory: read out DTC und readiness codes
Erase error memory
Vehicle information: can be used to read/print out all available OBD
information (VIN, ECUS, OBD standards, MIL data, DTC data, calibration ID,
CVN, IPT, …)
To Next Page
Loading...