Mahindra 10 Cab Series 4510C User Manual

36
First select the specified speed for the PTO by using the PTO shifter on the LHS, below the driver seat.
Glows
Blinks
Blinks
Glows
PTO Monitor
Lamp on the
dash panel
StationaryEither raised or
lowered
PressedAuto
Mode
On
RotatesLoweredReleasedAuto
Mode
On
StationaryRaisedEither pressed or
released
Auto
Mode
On
RotatesEither raised or
lowered
Either pressed or
released
Manual
Mode
On
PTO SHAFTHydraulic
Position
Control Lever.
Clutch Pedal.PTO
Control
Switch
PTO
ON/OFF
Switch
■ From the table above we learn about the safety features of the PTO. When the monitor on the dash
panel is blinking it indicates to the operator that the PTO is in the on position but temporarily not
rotating either because the clutch pedal is pressed or the implement is lifted off the ground or both.
The PTO will start rotating instantaneously when either the clutch pedal is released and/or the
implement is lowered to the ground.
■ The operator must use this blinking signal to clear the area around the tractor off
bystanders/onlookers as the rotating blades of certain implements can accidentally cause injuries to
the persons standing near the tractor.
■ The stopping of the PTO when the implement is lifted off the ground with the position control
prevents the damage to the implement or the PTO shaft.
1.When the PTO control switch is in manual position the PTO does
not stop rotating even if the clutch pedal is pressed. If working on
hard soils,pavements with a rotary implement the PTO ON/OFF
switch must be put to the OFF position to stop the PTO from
rotating, If this is not done the rotating blades of the implement
will push on the hard ground below and in turn push the tractor toward causing accident which can
lead to serious injuries or death.
2. Extra precaution must be taken to clear the area of bystanders/onlookers when using PTO driven
implements. The rotating blades of the implements can cause serious injuries on contact. The
warning that is indicated by the blinking PTO monitor is to make the operator aware that the
PTO is in on position and will instantly start rotating if the clutch pedal is released or implement
is lowered or both.
3.In no case the specified rotating speeds indicated by the implement manufacturer be crossed as the
same can lead to serious damage to the tractor/equipment and can lead to serious injuries to
persons around.
Warning

Mahindra 10 Cab Series 4510C Specifications

General

Brand	Mahindra
Model	10 Cab Series 4510C
Category	Tractor
Language	English