4-54
© Copyright Mahindra and Mahindra Ltd. 092018
4.19.4 Resuming The Set Speed (Resume)
If the auto cruise stopping conditions are met during the activation
of the auto cruise, the function of the cruise control is deactivated.
But the last set speed memorized in the ECU will be resumed when
the RES button is pressed.
The speed should be 40 km/h and the brake or accelerator pedal
should not be depressed. (Deactivation by cruise control OFF switch
will not restore the previous set speed.)
The set speed saved before the cruise control is OFF will be
resumed with the AUTO CRUISE indicator light appeared on the
instrument cluster, if the recovery conditions are met.
In order to respond to a sudden speed change after resuming
the set speed, you should always recognise how fast the saved
speed is. If the vehicle speed increases rapidly, step on the
brake pedal to control the speed.
4.19.5 Deactivating The Cruise Control System
The cruise control will be deactivated when any of the following
stopping conditions is met while it is activated. (READY indicator
illuminated)
Auto cruise stopping conditions (CANCEL)
• The brake pedal is depressed or ESP is activated
• Drive the vehicle at less than 40 km/h
• Parking brake is applied while driving
• ON/OFF switch operation (once) during auto cruise activation
(ON/OFF switch operation in auto cruise ready mode
deactivates cruise control)
STARTING THE ENGINE AND DRIVING THE VEHICLE
To Next Page
Loading...
