3-24
© Copyright Mahindra and Mahindra Ltd. 092018
belts, harnesses or for attaching other items or equipment
to the vehicle
How to use the Rear Anchor
• There are two rear anchors on the floor under the 3rd row seat.
(7-seater)
1. Remove the headrest from the second row seat
2. Place the child restraint on the second row seat
3. Connect the tether connector in child restraint to the rear
anchor. Securely tighten the child restraint by adjusting the
webbing of the tether connector
Cautions for ISOFIX Seat
• The rear anchor is the supplemental device to secure the
child restraint system after engaging it by the lower latches.
Therefore, do not secure the child restraint system only with
the seat back anchors. The increased load may cause the
hooks or anchors to break, causing serious injury or death
• If a child restraint is not properly secured to the vehicle and
a child is not properly restrained in the child restraint, the
child could be seriously injured or killed in a collision. Always
follow the instructions provided by the manufacturer for
installation
• Make sure the latches of the child restraint system are
latched to the lower latches. In this case, you can hear the
“click” sound
• Incorrectly installed child restraint system may cause an
unexpected personal injury
• Child restraint anchorages are designed to withstand only
those loads imposed by correctly fitted child restraints
• The tether strap may not work properly if attached
somewhere other than the correct rear anchor
• Rock the child restraint to check if it is securely installed.
Refer to instructions provided by the manufacturer of the
child restraint
• Do not instal the child restraint if it hinders the operations of
front seat
• All the procedures described here are to assist you in
understanding the child restraint system. Use this as a
reference only. When you install a child restraint to your
SAFETY UNIT
To Next Page
Loading...
