Maico PILOT TEST - Troubleshooting Common Issues

Operation Manual PILOT TEST
8504660 Rev. 3
32
06/11/2019
5.5.7 Device Information
Figure 27
General information can be found here (Figure 27).
• PILOT TEST: The firmware release date and
version installed on the device.
• Hardware ID: Internal serial number of the device.
• Version: Calibration standard selected.
• Date: Date device was calibrated.
5.5.8 Set date and time
Figure 28
Set the correct date and time of the device for
printing of tests (Figure 28).
Move to the available field with the
arrowkeys. To make a change, use the
arrow ▲ ▼ keys.
• Date: Set the current date.
• Date format: Select the preferred date format to
be displayed on the printout.
• Time: Set the current time. Hour and minute are
selectable for change. If time format 12H is
chosen AM/PM will be displayed.
• Time format: Select the preferred clock,
using the 12H or 24H time format.
5.5.9 Display Contrast
Figure 29
By pressing the(light) or(dark) key the
display can be adapted to your preference
(Figure 29).