Cable measurement
Ÿ Connect the cable to MT900 cable socket. (If the cable is a
network cable, connect the network cable to the MT900 RJ45
cable socket. If the cable is a coaxial cable, connect the
coaxial cable to the MT900 BNC socket.)
Ÿ Set the instrument to the cable measurement mode,
there are two ways to enter the cable measuring
interface:
The boot default interface is network cable measurement.
Press the button once to select network cable measurement,
coaxial cable measurement, or single-wire cable measurement.
1. Enter functions menu, press the or button to
select , then press the button once to enter El
the cable selection interface.
2. Then press the or button again to select the cable
measurement mode.
The second:
The first:
To Next Page
Loading...
