Non-Contact AC Voltage Measurements
1. Touch the probe tip to the hot (LIVE) conductor or insert
into the hot (LIVE) side of the electrical outlet.
2. If AC voltage is present, the detector red LED light will
illuminate.
a. NOTE: The conductors in electrical cord sets are
often twisted. For best results, rub the probe tip
along a length of the cord to assure placing the tip
in close proximity to the live conductor.
b. NOTE: The detector is designed with high
sensitivity. Static electricity or other sources of
energy may randomly trip the sensor. This is normal
operation
HOLD/Flashlight & LCD Backlight
To freeze the LCD reading, press the button. While
data hold is active, the HOLD icon appears on the LCD. Press
the button again to return to normal operation.
The LCD is equipped with backlighting for easier viewing,
especially in dimly lit areas. Press the Select Key button for 3
seconds to turn the Flashlight and LCD backlight on. Press
again for 3 seconds to turn the Flashlight and backlight off.
The both work simultaneously.
To Next Page
Loading...
