10
Continuinuing the Strega Experiment
The many symbols, lines, and arrows on Strega indicate potential connections between circuits.
Bridge these connections with patch cables or, in the case of the Touch Bridges and Gateways, by
pressing on two or more with your fingers. Where there are input attenuators, use them to control
the depth of the connections.
Symbols indicate types of signals, lines map the alchemic paths of the signals, and gold arrows
indicate pre-wired signal connections that can be broken by patch cable. Make connections,
observe symbols, and listen to the results in order to get a feel for the nature of the different signals
that are available.
Patch external audio signals to the External Substance In for processing by Strega. Add gain if
necessary with the Strength control, patch the Strength output wherever you like, or add the signal
to the Time/Filter experiment by turning up the External Constant control. A DC Voltage
representation of the External In appears at the CV 1 output.
External Substance In ->
<- Strength Output
External Constant Control ->
To Next Page
Loading...