Make Noise Strega - Beginning the Strega Experiment (cont.); Absorb and Filter Controls; Agitation Function Generator

9
Beginning the Strega Experiment (cont.)
Adjust the Absorb control through the entire range ending at full CW. Now sweep the Filter control
through the entire range ending at full CCW.
Set the Filter CV Attenuator Full CW and focus your attention on the Agitation Function Generator.
Adjust the Speed and Angle parameters through their ranges so you may understand how they could be
used to agitate the Strega.
Speed ->
Angle ->
<- Filter CV Attenuator
You’ve completed the initial experiment. Put all controls back to 12:00.