1. Connect a computer to the Laserbox with the USB cable. 2. Open the soware, select “Connect to a
new Laserbox” and click “Next”.
3. Select “USB” and click “Next” to start the
connection.
4. Successful connection.
Connect with the USB cable
14
13
1
2 3 4
Back Next
Select your preferred connection mode.
Device connection
USB Wi-FiEthernet
Cancel Next
Select your preferred connection method.
Device connection
Connect to a new
Laserbox.
Connect to a networked
Laserbox.
Finish
Connected successfully!
Go and enjoy the fun of creation!
To Next Page
Loading...
