Makeblock laserbox - Page 11

Finish
Connected successfully!
Go and enjoy the fun of creation!
Back Next
Select your preferred connection mode.
Device connection
USB Wi-FiEthernet
Cancel Next
Select your preferred connection method.
Device connection
Connect to a new
LaserBox.
Connect to a networked
LaserBox.
1. Connect your computer to the Laserbox with an Ethernet cable.
2. Open the soware, select “Connect to a
new Laserbox” and click “Next”.
3. Select “Ethernet” and click “Next” to start
the connection.
4. Successful connection.
Connect with an Ethernet cable (not included in the package)
1
15
16
2 43