Makeblock mBot Servo Pack

To Next Page

To Previous Page

14 15

Step 3

Step 4

9g Micro Servo ×1

9g Micro Servo Bracket ×1

Servo Arm ×1

M2×10mm Screw ×2

M2 Nut ×2

M2.2×6.5mm Self-drilling Screw ×1

Plate I1-Blue ×1

Me RJ25 Adapter Module ×1

M4×8mm Screw ×4

M4 Nut ×2

Firstly, you should adjust servo to 90 degrees with software,

then install servo arm to the servo (pay attention to their angle).

Step 5

Step 6

Bracket 3×3 ×1

M2.2×8mm Self-drilling Screw ×2

Plastic Spacer 4×7×2mm ×2

Me Ultrasonic Sensor ×1

M4×8mm Screw ×2

M4 Nut ×2

Please insert self-drilling

screw through the hole

marked red.

The ultrasonic sensor is

included in mBot.

Tip

Makeblock mBot Servo Pack - Page 9