Precautions
1.
Do not use the printer for any use or purpose other than those described in this manual, as that
may cause accidents or damage to the product.
2.
Only MakeID official labels can be used for this printer. Thus, please do not use other branded
labels as the replacement, as this may cause damage to the printhead and shorten its life.
damage to the printhead caused by the use of poor-quality labels are not covered by the
warranty.
3.
Do not touch the printhead to prevent static electricity from causing damage to sensitive
components. If the printhead gets dirty, please clean it with anhydrous alcohol.
4.
Do not scratch the printhead with hard objects. damage to the printhead caused by improper
maintenance or use are not covered by the warranty.
5.
Do not place any foreign objects outside the label exit, as this may cause damage to the printer.
6.
Do not press or hit the printer, as this may cause damage to the components or the printer to
malfunction.
7.
If the printer is soaked in water or damaged, stop using it immediately.
8.
The printer should be kept away from direct sunlight or the rain, heaters and other heat-
generating devices, dashboards, the rear of the cars, nor exposed to extremely high or low
temperatures, high humidity, or dusty areas. The standard operating temperature range is from
5°C to 35°C;
9.
If there is a large temperature difference between indoors and outdoors, it is not recommended
to use the printer immediately when it is taken from outdoors to indoors. It needs to be left to
stand for a period of time to ensure that the printer is frost-free before use;
10.
Do not stick the label where your hands often touch. Sweat and friction will make the printings
fade.
11.
Do not leave the labels in contact with chemical liquids, such as hand sanitizer, laundry
detergent, detergent, alcohol, etc. for a long period, otherwise, it will affect the preservation
To Next Page
Loading...
