13
③ Confirm the ECO selecting interface. After selecting ON or OFF, press and hold
the function setting key for more than half a second (less than 2 seconds). Now, the
ECO setting function is completed and the “ON” or “OFF” below the “ECO” will light
without flash.
④Set the ECO tolerance range. Short press the scroll key or for more than half a
second (shorter than 2 seconds)to select the voltage range in percentage.
+5%,+10%,+15%,+25%(default is +25%)，then short press function setting key
for more than half a second (shorter than 2 seconds)to confirm the selection, then to
set the minus range
⑤To set the minus range in the same way.
⑥ Exit from the setting interface. Press and hold function setting key for more
than 2 seconds, exit from the setting interface and turn to main interface.
4.3.2 Bypass mode setting(2)
① Enter the setting interface. Press and hold the function setting key for more than
2 seconds, then come to setting interface, Press and hold the function setting
key for more than half a second(less than 2 seconds), select the function setting,
choose the bypass output interface, at the moment, the letters “bPS” will flash
② Enter the Bypass output selecting interface. Press and hold the function setting
key for more than half a second(less than 2 seconds), then come to setting
interface of bPS, at this time, the letters “bPS” will light for a long time. The “ON”
To Next Page
Loading...
