MAINTENANCE
CAUTION:
Always be sure that the tool
is
switched off and unplugged before attempting to perform
inspection or maintenance.
Cleaning the
clamp
on
the
blade holder
If chips or foreign matter
get
into the clamp on the blade holder, clean out
the
clamp
after removing
it
from the blade holder. To remove the clamp, rotate the blade installing
lever (for 4304T) or knob (for 4305T) in the blade loosening direction
as
far
as
it
will go.
Then remove the clamp from the blade holder while rotating the clamp counterclock-
wise. To install the clamp, first make sure that the blade installing lever (for 4304T) or
knob (for 4305T) has been rotated in the blade loosening direction
as
far
as
possible.
Insert the clamp into the blade holder while rotating
it
clockwise one quarter to one full
turn. Grasp the clamp with your fingers
so
that
it
will not turn, then rotate the blade
installing lever or knob in the blade tightening direction
so
that the clamp will go into the
blade holder.
8
Blade holder
Clamp
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed
by
Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
12
To Next Page
Loading...
Need help?
General
