EasyManuals Logo

Makita 4304T User Manual

Makita 4304T
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Flush cutting
Loosen
the
base securing
lever
and slide the
base
all
the way back. Then tighten the
base securing lever to secure the base.
cutouts
Cutouts can be made with either
of
two methods A or
B.
A) Boring
a
starting hole:
For internal cutouts without
a
lead-in
cut from and edge, pre-drill starting hole
more than 12 mm (1 5/32") in diameter.
Insert the blade into this hole and hold
the tool firmly against the workpiece
to start your cut.
B)
Plung cutting:
You need not bore
a
starting hole
or
make
a
lead-in cut if you carefully
do
as
follows:
1.
Tilt the tool up on the front edge of
the base, with the blade point posi-
tioned just above the workpiece sur-
face.
2. Apply firm pressure to the tool
so
that the front edge
of
the base will
not move when you switch on the
tool and gently lower the back end
of the tool slowly.
\
,-,/---
3. As the blade slices into the workpiece, slowly lower the base
of
the tool down onto
4.
Complete the cut in the normal manner.
the workpiece surface.
9

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Makita 4304T and is the answer not in the manual?

Makita 4304T Specifications

General IconGeneral
BrandMakita
Model4304T
CategoryPower Tool
LanguageEnglish

Related product manuals