To Next PageTo Next Page
Need help?Do you have a question about the Makita DDF480Z and is the answer not in the manual?
General| Model | DDF480Z |
|---|---|
| Category | Drill |
| Type | Cordless |
| Power Source | Battery |
| Battery Voltage | 18V |
| Chuck Capacity | 1.5 - 13 mm |
| Max. in steel | 13 mm |
| Max. in wood | 38 mm |
| Weight | 1.7 kg |
| Chuck Size | 13mm |
| No Load Speed (Hi) | 1, 700 rpm |
Defines the tool's purpose for drilling and screw driving in wood, metal, and plastic.
Details the A-weighted noise levels for models DDF470 and DDF480 according to EN60745.
Specifies the total vibration value for drilling into metal according to EN60745.
Provides safety precautions for operating the cordless driver drill, covering handling and wiring.
Outlines essential safety rules for using, storing, and handling the battery cartridge.
Details the procedure for attaching and detaching the battery cartridge from the tool.
Explains the protection system that automatically cuts off power to extend battery life.
Explains how to install and remove drill bits and driver bits from the chuck.
Describes how to install and use the tool's hook for temporary hanging.
Details how to fit and use the optional bit holder for storing bits.
Guides on adjusting torque and performing screw driving tasks, including pilot holes.
Provides instructions for drilling in wood and metal, including preparatory steps.
