Need help?Do you have a question about the Makita DDF485 and is the answer not in the manual?
General| Voltage | 18V |
|---|---|
| Max Torque | 50 Nm |
| No Load Speed (High) | 0 - 1, 900 RPM |
| No Load Speed (Low) | 0 - 500 RPM |
| Chuck Capacity | 1.5 - 13 mm |
| Dimensions (L x W x H) | 169 x 79 x 255 mm |
| Max. in steel | 13 mm |
| Max. in wood | 38 mm |
| Battery Type | Li-ion |
| Length | 169 mm |
Displays symbols used for the equipment and their meanings for proper understanding before use.
Details the vibration total value according to EN60745-1 for specific work modes like drilling into metal.
Specifies the tool's purpose: drilling and screw driving in wood, metal, and plastic materials.
Provides the typical A-weighted noise level determined according to EN60745-2-1.
Instructions to read all safety warnings, instructions, illustrations, and specifications before operating the tool.
Guidelines for maintaining a clean, well-lit work area and keeping children and bystanders away.
Advice on preventing electric shock, including proper plug matching and avoiding wet conditions.
Recommendations for staying alert, using personal protective equipment, and proper attire.
Guidance on using the correct tool, not forcing it, and ensuring the switch functions correctly.
Instructions for charging, using, and handling battery packs to prevent hazards.
Advice on having the power tool serviced by qualified personnel using identical replacement parts.
Specific safety instructions for using cordless driver drills, including handling and battery precautions.
Precautions for handling battery cartridges, including avoiding short circuits and improper charging.
Instructions on how to correctly install and remove the battery cartridge into the tool.
Explains how to check the remaining battery capacity using indicator lamps on the battery cartridge.
Details the systems for overload, overheat, and overdischarge protection that automatically cut off power.
How to operate the switch trigger to start, stop, and control the tool speed.
Instructions on how to use the front lamp for illumination during operation.
How to change the direction of rotation using the reversing switch lever.
Instructions on how to adjust the speed change lever for different drilling or driving applications.
How to adjust the fastening torque using the adjusting ring and graduations for different screw sizes.
Steps to insert and secure drill bits or driver bits into the chuck.
How to install the hook for temporarily hanging the tool on either side.
Instructions for fitting the driver bit holder to the tool foot for storing driver bits.
General guidance on operating the tool, including battery insertion and handling the twisting action.
Steps for driving screws, including adjusting torque and starting slowly with gradual speed increase.
General steps for drilling, followed by specific guidance for drilling in wood and metal.
Warnings against excessive pressure, holding the tool firmly, and dealing with stuck drill bits.
Instructions for maintenance, including switching off the tool and removing the battery before inspection.
List of recommended accessories and attachments for use with the tool, stressing the use of genuine parts.
To Next Page
