To Next PageTo Next PageWhy is the suction power weak on my Makita Vacuum Cleaner, and it's not picking up dust?
If your Makita Vacuum Cleaner has weak suction or isn't picking up dust, the dust box might be full, or the filter could be clogged. Dispose of the dust and clean the filter. Also, check if the vacuum fan is turned off and adjust the setting accordingly.
Why does my Makita DRC300PG2 start moving suddenly?
The ON timer reservation might be enabled, causing the robotic cleaner to start moving suddenly.
Why does my Makita Vacuum Cleaner not run?
If your Makita Vacuum Cleaner is not running, it could be due to the following reasons: * The error lamp might be blinking. The cleaner will not run during an error. * The cleaner might be in the waiting mode for operation by ON timer reservation. Operations other than turning off the power and location notification are not possible in this mode.
Why does the set time on my Makita DRC300PG2 keep resetting?
If the set time on your Makita Vacuum Cleaner frequently resets, the built-in battery is likely low due to the cleaner not being used for a long time. Run the cleaner for more than an hour or leave it in standby to recharge the battery.
Why does my Makita DRC300PG2 Vacuum Cleaner continue avoidance behavior with no obstacles?
If the robotic cleaner continues to perform avoidance behavior even without obstacles or steps, the cliff sensors or LiDAR sensor might be dirty. Ensure you care for them.
Why does the time reset on my Makita DRC300PG2?
If the set time on your Makita Vacuum Cleaner is frequently reset, the built-in battery may be low from not being used for a long time. Run the cleaner for more than 1 hour, or leave it in standby to recharge the battery.
How to troubleshoot a Makita Vacuum Cleaner that won't turn on?
If pressing the start/stop button on your Makita Vacuum Cleaner doesn't turn on the power, and the lamp doesn't light up, first check if the batteries are installed correctly. If they are, check the remaining battery capacity. Also, ensure that the power of the robotic cleaner is turned on by pressing the start/stop button on the cleaner itself.
Why is my Makita DRC300PG2 Vacuum Cleaner so loud?
If your Makita Vacuum Cleaner is louder than usual, the dust box might be full, or the filter could be clogged. Dispose of the dust and clean the filter. Also, check if dust is caught in the main and side brushes, ensuring they are installed correctly.
Why doesn't the remote control work for my Makita DRC300PG2 Vacuum Cleaner?
If your Makita Vacuum Cleaner's remote control isn't working, consider these potential causes: * The batteries in the remote control might be incorrectly placed. Check the battery orientation. * The batteries may be at the end of their life. Replace them with new ones. * The cleaner itself might be turned off. Press the start/stop button on the cleaner to turn it on. * The distance between the remote control and the cleaner might be too far. Reduce the distance and remove any obstacles.
What to do if the remote control of my Makita DRC300PG2 Vacuum Cleaner does not work?
If the remote control for your Makita Vacuum Cleaner isn't working, first check if the batteries are correctly placed. If the batteries are old, replace them with new ones. Make sure the robotic cleaner is powered on. Also, ensure that there isn't too much distance or any obstacles between the remote control and the cleaner.
General| Model | DRC300PG2 |
|---|---|
| Category | Vacuum Cleaner |
| Type | Cordless |
| Power Source | Battery |
| Battery Type | Lithium-ion |
| Battery Voltage | 18V |
| Dust Collection Method | Bagless |
| Hose Length | 2.5 m |
| Filter Type | HEPA |
