Makita DSL801TUX2 - Page 10

10 ENGLISH
Adjusting the pipe length
CAUTION: When adjusting the pipe length,
hold the tool horizontally. Otherwise, the pipe
lengthmaychangeunintentionallyanditmaycause
aninjuryormalfunctionofthetool.
NOTICE: Do not extend the pipe beyond the
limit.Failuretodosomaycauseamalfunctionof
the tool.
2
1
►1. Sleeve 2. Pipe
Toadjustthepipelength,loosenthesleeve,thenadjust
the length of the pipe, and then tighten the sleeve.
Hex wrench storage
1
►1. Hex wrench
When not in use, store the hex wrench as shown in the
guretokeepitfrombeinglost.
Installing or removing the pad
1
2
3
►1. Hex wrench 2. Bolt 3. Pad
To remove the pad, remove the abrasive disc from the
pad, and then turn the bolt counterclockwise with a hex
wrench. To install the pad, perform the removal proce-
dure in reverse.
CAUTION: Make sure that the pad is secured
properly. Loose attachment will run out of balance
andcauseanexcessivevibrationwhichmaycause
loss of control.
Connecting a vacuum cleaner
Optional accessory
Whenyouwishtoperformoperationcleanly,connecta
Makitavacuumcleanertoyourtool.Connectahoseof
the vacuum cleaner to the dust nozzle using the front
cu󰀨24.
1 2
3
►1. Hose of the vacuum cleaner 2.Frontcu󰀨24
3. Dust nozzle