Makita DSL801TUX2 - Page 11

11 ENGLISH
Installing or removing the extension
handle
Optional accessory
To install the extension handle, attach the extension
handletothetoolandsecureitwiththeknobrmly.Be
sure to insert the end of the tool into the holder of the
extension handle. To remove the extension handle,
perform the installation procedure in reverse.
1
2
3
4
5
►1. Extension handle 2.Knob3. Holder 4. End of tool
5. Mounting hole
WARNING: Use the mounting hole of the tool
only for attaching the extension handle.
Usingthemountingholeforanyotherpurposemay
cause an unexpected accident.
OPERATION
CAUTION: Only use Makita genuine pads for
sanding (optional accessories).
CAUTION: Make sure the work material is
secured and stable. Falling object may cause
personal injury.
CAUTION: Hold the tool rmly with one hand
on the switch handle and the other hand on the
front grip when operating the tool.
CAUTION: Do not run the tool at high load
over an extended time period.Itmayresultintool
malfunctionwhichcauseselectricshock,reand/or
seriousinjury.
CAUTION: Be careful not to touch the rotating
part.
NOTICE: Never force the tool. Excessive pressure
mayleadtodecreasedsandinge󰀩ciency,damaged
pad, or shorten tool life.
NOTICE: Continuous operation at high speed
may damage work surface.
1. Positionthetoollightlyagainsttheworksurface.
Applylightpressureenoughtoalignthesandinghead
with the work surface.
2. Applyadditionalpressuretoengagethepad
on the work surface. Move the tool in an overlapping
patterninconstantmotiontosmooththedrywall
compound.
Operating the tool with the
extension handle
Optional accessory
CAUTION: Hold the tool rmly with one hand
on the switch handle and the other hand on the
extension handle when operating the tool with the
extension handle.
CAUTION: Take extra care for the footing and
balance when handling the tool with the extension
handle.