To Next PageTo Next PageWhat to do if my Makita Cordless Saw chain is not running?
If the saw chain on your Makita Cordless Saw isn't running, it's likely that the chain brake is activated. Release the chain brake to allow the chain to run.
Why won't my Makita Cordless Saw start?
Your Makita Cordless Saw might not start due to several reasons: the battery cartridge may not be installed (install a charged battery cartridge), the battery may have low voltage (recharge or replace the battery), or the main power switch is off (turn on the main power switch again, as the saw automatically turns off after a period of inactivity).
Why is there no oil on the chain of my Makita DUC204 Chainsaw?
If there is no oil on the chain of your Makita Chainsaw, start by checking if the oil tank is empty and fill it if needed. Also, the oil guide groove might be dirty, so clean it. If the oil delivery is poor, adjust the amount of oil delivery with the adjusting screw.
What to do if Makita Chainsaw motor stops running quickly?
If the motor of your Makita chainsaw stops running after a short period, the battery's charge level might be low. Try recharging the battery cartridges, and if that doesn't work, replace the battery cartridge.
What to do if the saw chain of my Makita DUC204 Chainsaw does not run?
If the chain on your Makita Chainsaw does not run, the chain brake may be activated. Release the chain brake to allow the chain to move freely.
How to fix no oil on the chain of my Makita DUC204 Chainsaw?
If there's no oil on the chain of your Makita Chainsaw, first check if the oil tank is empty and fill it if necessary. Also, inspect the oil guide groove for dirt and clean it. If the oil delivery is poor, adjust the amount of oil using the adjusting screw.
What to do if my Makita Chainsaw motor stops after a little use?
If the motor of your Makita Chainsaw stops running after a short period, it's likely due to a low battery charge. Recharge the battery. If the issue persists after recharging, consider replacing the battery cartridge.
Why is my Makita Chainsaw not reaching maximum RPM?
If your Makita Chainsaw is not reaching maximum RPM, the battery cartridge might be installed improperly; make sure to install it correctly as described in the manual. It's also possible that the battery power is dropping, so try recharging or replacing the battery cartridge. If these steps don't resolve the issue, it could be a problem with the drive system, which would require professional repair from an authorized service center.
What to do if my Makita DUC204 Chainsaw has abnormal vibration?
If your Makita Chainsaw is vibrating abnormally, it could be due to a loose guide bar or saw chain; adjust the guide bar and saw chain tension to resolve this. If the issue persists, it may indicate a tool malfunction, and you should ask the authorized service center in your region for repair.
What to do if the saw chain does not run on my Makita DUC204 Chainsaw?
If the saw chain of your Makita Chainsaw does not run, it is likely because the chain brake is activated. Release the chain brake to allow the chain to run.
Typical A-weighted noise levels (sound pressure and power) for DUC204, DUC254, DUC254C models.
General and specific safety guidelines for operating the power tool and chain saw.
Precautions for battery handling, charging, storage, and proper disposal.
Procedures to test the chain brake and run-down brake for proper function.
When and how to sharpen the saw chain, including sharpening criteria.
Methods for sharpening saw chain, including file use and angles.
Table outlining periodic maintenance checks and their frequency.
Table listing malfunctions, their causes, and recommended actions.
General
