Model No.
Description
Standard equipment
Optional accessories
Note: The standard equipment for the tool shown above may vary by country.
JN3201
Nibbler 3.2mm (10Ga)
Punch
Die
Punch
.................................................. 1
Die ....................................................... 1
Wrench 50 .......................................... 1
Hex wrench ........................................ 1
Washer ............................................... 2
Plastic carrying case .......................... 1 (for some country only)
PRODUCT
Outer edge: 128 (5-1/16),
Inner edge : 120 (4-3/4)
T
ECHNICAL INFORMATION
CONCEPT AND MAIN APPLICATIONS
P 1/ 9
Dimensions: mm (")
Width (W)
Height (H)
Length (L)
225 (8-7/8)
90 (3-1/2)
254 (10)
Model JN3201 Nibbler is the aesthetic change model of current model JN3200
by using Motor housing of Angle grinder GA5010 series and Rubberized soft grip.
Its Blade section is the same as Nibbler JN3200.
Addition to the above, it has the following advantages.
• 710W continuous rating input
• Low noise level at 81 dB(A)
L
W
H
Specification
Continuous Rating (W)
Voltage (V) Cycle (Hz)
Input Output
Max. Output (W)
110
120
220
230
240
6.8
6.2
3.4
3.3
3.1
50/60
50/60
50/60
50/60
50/60
710
---
710
710
710
400
400
400
400
400
600
600
700
700
700
Current (A)
Max cutting capacities:
mm (Ga)
Steel with tensile strength
up to 600N/mm²
Weight according to EPTA-Procedure 01/2003*: kg (lbs)
3.4 (7.4)
2.5 (13)
Steel with tensile strength
up to 800N/mm²
1.0 (20)
Aluminum with tensile
strength up to 200N/mm²
3.5 (10)
Steel with tensile strength
up to 400N/mm²
3.2 (10)
No load speed: min.
ˉ¹=spm (strokes per minute) 1,300
Minimum cutting radius: mm (")
Power supply cord: m (ft)
European countries: 4.0 (13.1),
Australia, New Zealand: 2.0 (6.6)
Other countries: 2.5 (8.2)
* with Punch and Die