To install the blade, mount the inner flange,
saw blade, outer flange and hex bolt onto
the spindle in that order. Tighten the hex
bolt by turning clockwise while pressing the
shaft lock. Return the safety cover and
center cover to the original position. Then
tighten the hex bolt clockwise to secure the
center cover. Lower the handle to make
sure that the safety cover moves properly.
Carbide-tipped saw blade Hex bolt
I
I7
Setting for desired cutting angle
CAUTION:
Always tighten the hex bolt securely after changing the cutting angle.
To change the cutting angle, loosen the
lever. Move the vise stop
so
that the indi-
cator
will
point to the desired graduation.
Then tighten the lever to secure the vise
stop.
Graduation Indicator
Securing workpieces
CAUTION:
Always set the vise nut to the right fully when securing the workpiece. Failure to do
so
may result in insufficient securing of the workpiece. This could cause the workpiece to be
ejected or cause damage to the blade.
By
turning the vise handle counterclock-
wise and then flipping the vise nut to the
left, the vise is released from the shaft
threads and can be moved rapidly in and
out. To grip workpieces, push the vise
handle until the vise plate contacts the
workpiece. Flip the vise nut to the right and
then turn the vise handle clockwise to
securely retain the workpiece.
Vise plate Vise nut
I
9
To Next Page
Loading...
