MOUNTING OF HANDLE
CAUTION: Before doing any work on the brush cutter, always stop the engine and
pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the brush cutter only after having assembled it completely.
RBC2500
RBC2500
RBC2510
to Engine
For machines with Loop Handle models
Fix a barrier to the left side of the machine together with the handle for operator –
protection.
– Do not adjust position of the loop handle too close to the control grip.
– The standard position of the handle is 200 mm to 250 mm from the hanger.
For machines with U Handle models
Place the handle-fixing metal so that the handle with the control lever will be –
positioned on the right (the right-hand grip side) as viewed from the engine side,
and the other handle on the left side.
Fit the groove of the handle-fixing material to the handle end. Fix provisionally the –
attached metal by hexagon socket bolt supplied.
Adjust the handle to an easy-to-operate position, and tighten securely the four –
hexagon socket bolts uniformly on the right and left by Allen wrench.
Wrap the waist pad around the shaft so that the hanger (1) will protrude through –
the slit in the waist pad and the control cable and the cords (3) will also be
wrapped under the waist pad (2).
10
To Next Page
Loading...
