Makita RST250 User Manual

WHAT IS NOT COVERED UNDER THIS WARRANTY
This warranty does not cover any emission-related part which malfunctions, fails, or
is damaged due to alterations and/or modifications such as changing, adding, or remov¬
ing parts.
When an engine is being serviced under warranty, Makita U.S.A., Inc. and any of its
authorized dealers, distributors, or warranty stations shall not be liable for any loss of
use of the engine, for any damage to goods, or loss of time or inconvenience.
This limited warranty also does not apply to any emission-related part which malfunc¬
tions, fails, or is damaged due to failure to follow the maintenance and operating
instructions specified in the 1995 and later Owner’s Manual including:
(a) Improper or inadequate maintenance of any warranted emission-related part.
(b) Improper installation, adjustment, or repair of the engine or any warrated emission-
related part unless performed by a factory authorized warranty station.
(c) Failure to use recommended fuel as specified in the 1995 and later Owner’s Manual.
(d) Repairs and diagnosis performed outside of an authorized warranty station.
(e) Use of parts which are not authorized by Makita U.S.A., Inc.
MAINTENANCE SCHEDULE
The engine owner is responsible for having all scheduled inspection and maintenance
services performed at the intervals specified in the 1995 and later Owner’s Manual
and to retain records of these services as having been performed. These records should
be transferred to each subsequent owner of the engine. Makita U.S.A., Inc., cannot
deny a claim solely because there are no records of scheduled maintenance; however,
a warranty claim may be denied if the failure to perform the scheduled maintenance
and inspection resulted in the failure of a warranted emission-related part. As a mini¬
mum, the engine owner is responsible for the scheduled inspection and maintenance
described below which are based on the procedures described in the Owner’s Manual.
PROCEDURE
INTERVAL
(a) Check all nuts and bolts and tighten as necesary.
(b) Check air passages and engine cylinder fins for clogging.
Remove all obstructions as necessary.
(c) Clean air cleaner.
(d) Check spark plug. Clean and adjust if necesary.
(e) Check muffler exhaust port. Clean if necessary.
(f) Check fuel filter. If clogged, replace with new filter.
(g) Replace fuel lines.
(h) Overhaul engine.
(i) Replace packings and gaskets.
Every 8 hours of use or daily.
Every 8 hours of use or daily.
Every 8 hours of use or daily.
Every 8 hours of use or daily.
Every 50 hours of use or monthly.
Every 50 hours of use or monthly.
Every 200 hours of use or annually.
Every 200 hours of use or annually.
Every time engine is reassembled.

Makita RST250 Specifications

General

Brand	Makita
Model	RST250
Category	Trimmer
Language	English