Makita RT0702CX2J - Circular work

15 ENGLISH
 Moving the tool forward too fast may cause


and mar the cut. The proper feed rate will depend on





CAUTION: Since excessive cutting may cause
󰀩

at a pass when cutting grooves. When you wish to cut
grooves more than 3 mm deep, make several passes


Optional accessory


 1. Clamping screw

clamping screw at the desired protrusion of the trimmer

For the operation procedures, refer to the operation for


Optional accessory
The templet guide provides a sleeve through which the

templet patterns.
Fig.13
1. 
protector.
 1.2. Screws
2. 
-

3. Secure the templet to the workpiece. Place the
tool on the templet and move the tool with the templet
guide sliding along the side of the templet.
 1.2.3.
4. Templet 5. Workpiece 6. Templet guide
󰀨



the following equation:



Optional accessory
󰀨
when chamfering or grooving.
Fig.16
1. Attach the guide plate to the straight guide with

 1.2. Guide plate 3. Straight guide
4. Wing nut
2. -
ing screw.
 1. Clamping screw 2. Straight guide 3. Wing
nut 4.
3. -

the straight guide. At the desired distance, tighten the
wing nut securely.
4. When cutting, move the tool with the straight guide


the cutting position is too wide for the straight guide, or
if the side of the workpiece is not straight, the straight



of the arrow.
Fig.19






Min.: 70 mm
Max.: 221 mm


 1. Wing nut 2. Guide plate 3. Straight guide
4. Center hole 5.


 1. Wing nut 2. Guide plate 3. Straight guide
4. Center hole 5.


1. Align the center hole in the straight guide with the

 1. Nail 2. Center hole 3. Straight guide
2. Drive a nail less than 6 mm in diameter into the
center hole to secure the straight guide.
3. Pivot the tool around the nail in clockwise
direction.