Makita TM30D - Assembly and Tool Application; Tool Assembly; Application Tool Installation

7 ENGLISH
Adjusting the orbital stroke rate
1
Fig.4
►1. Dial
Theorbitalstrokerateisadjustable.Tochangethe
orbitalstrokerate,turnthedialbetween1and5.The
higher the number is, the higher the orbital stroke rate is.
Presetthedialtothenumbersuitableforyourworkpiece.
NOTE: Thedialcannotbeturneddirectlyfrom1to5orfrom5to1.
Forcingthedialmaydamagethetool.Whenchangingthedialdirec-
tion, always turn the dial moving it through each intermediate number.
Lighting up the front lamp
CAUTION: Do not look in the light or see the
source of light directly.
1
Fig.5
►1. Front lamp
Slidetheslideswitchtowardthe"I(ON)"positionto
lightupthefrontlamp.Thelampkeepsonlightingwhile
theswitchisthe"I(ON)"position.
Thelightautomaticallygoesoutafterpressingtherear
of the slide switch, and then sliding the slide switch
towardthe"O(OFF)"position.
Overload protection
Whenthetoolisoverloadedandtemperatureofthetoolorthe
battery cartridge reaches a certain level, the front lamp blinks
and the tool automatically stops. Remove a cause of overload,
and cool down the tool and the battery cartridge to restart.
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing application
tool
Optional accessory
WARNING: Do not install application tool
upside down. Installing application tool upside down
maydamagethetoolandcauseseriouspersonalinjury.
NOTE: Install application tool in the correct direc-
tion according to your work.Applicationtoolcanbe
installed at an angle of every 30 degree.
ToInstallanapplicationtool(optionalaccessory),puttheappli-
cationtoolonthetoolangesothattheprotrusionsofthetool
angetintheholesintheapplicationtool.Thensecurethe
applicationtoolbytighteningtheboltrmlywiththehexwrench.
1
2
3
Fig.6
►1.Protrusionsofthetoolange2. Holes in the
application tool 3.Applicationtoolinstallationbolt
1
2
3
Fig.7
►1.Applicationtoolinstallationbolt2. Hex wrench
3.Tighten
Toremovetheapplicationtool,loosenandremovethe
application tool installation bolt using a hex wrench and
then take off the application tool.
Whenusingthetoolasasander,setasandingpaper
onthesandingpad(hookandlooptting).
Make sure that their shape and dust extraction holes
match each other when setting.