Makita TM30D - Operation Guide; Cutting, Sawing, Scraping

8 ENGLISH
3
1
2
Fig.8
►1.Sandingpad2.Tighten3.Sandingpaper
Toremovethesandingpaper,raiseitsendandpeelitoff.
Whenusingapplicationtoolswithadifferenttypeof
installation section, use a correct adapter (optional
accessory).
1
2
3
4
Fig.9
►1.Applicationtoolinstallationbolt2. Holes in the
application tool 3.Adapter(requiredforsomeappli-
cation tools) 4.Protrusionsofthetoolange
Hex wrench storage
1
Fig.10
►1. Hex wrench
Whennotinuse,storethehexwrenchasshowninthe
guretokeepitfrombeinglost.
OPERATION
WARNING: Before starting the tool and
during operation, keep your hand and face away
from the application tool.
CAUTION: Do not apply excessive load to the
tool which may cause a motor lock and stop the tool.
CAUTION: Do not operate the tool with press-
ing the battery cartridge against the tool.
Cutting, sawing and scraping
CAUTION: Do not move on the tool forcibly in
the direction (eg. towards either side) of tool appli-
cation with no cutting edge. It may damage the tool.
Fig.11
Puttheapplicationtoolontheworkpiece.
Andthenmovethetoolforwardsothattheapplication
tool movement does not slow down.
NOTE: Forcing or excessive pressure on the tool may
reduceefciency.
NOTE: Before cutting operation, it is recommended to
presettheorbitalstrokerate3-5.
Sanding
CAUTION: Do not reuse a sanding paper used
for sanding metal to sand wood.
CAUTION: Do not use a worn sanding paper
or sanding paper without grit.
Applyasandingpaperontheworkpiece.
Fig.12