Makita TM30D - Maintenance and Accessories; Tool Maintenance

9 ENGLISH
NOTE:Usingatestmaterialsampletotryisrecom-
mendable to determine a correct orbital stroke rate
suitable for your work.
NOTE:Useasandingpaperwiththesamegrituntil
sanding the whole workpiece is completed. Replacing
a sanding paper with different grit sanding paper may
notgetanenish.
Dust extraction attachment
Optional accessory
CAUTION: Do not use the dust extraction
attachment when sanding metal.Suckingspark
and hot particle results in smoking and ignition.
1
4
3
7
8
6
2
5
Fig.13
►1. Dust nozzle 2. Joint 3. Dust attachment 4. Nozzle
band 5. Holes in the tool 6. Felt ring 7.Sandingpad
8.Applicationtoolinstallationbolt
1. Installjoint,dustnozzleanddustattachment.
2. Install the nozzle band on the tool so that its pro-
trusionstintheholesinthetooltosecureit.
3. Putthefeltringandthesandingpadonthedust
attachment and then secure them with the application
tool installation bolt.
Toperformcleaneroperation,connectavacuum
cleaner to the tool. Connect a hose of vacuum cleaner
to the dust extraction attachment (optional accessory).
Fig.14
MAINTENANCE
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE: Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
TomaintainproductSAFETYandRELIABILITY,
repairs,anyothermaintenanceoradjustmentshould
beperformedbyMakitaAuthorizedorFactoryService
Centers, always using Makita replacement parts.